map

Brass Inserts      Brass Inserts

 BRASS INSERTS BRASS MOULDING INSERTS BRASS MOLDING INSERTS BRASS INSERTS FOR PLASTIC MOULDING  BRASS INSERTS FOR PLASTIC MOLDING INJECTION MOLDING

 Brass inserts Brass Moulding Inserts Brass Plastic Moulding Inserts Brass Plastic Molding inserts Brass Injection Moulding Inserts Brass Injection Molding Inserts Brass roto molding Roto moulding inserts Brass inserts for cold moulding Hot insert molding

Special Features :

• Threads as per International Go & Not Go Standards. Brass Stainless Steel Nuts Moulding inserts molding nuts 

• Deep Groove for maximum Pull Out Resistance.

• Inner Diameter (I/D) after Threads with very close tolerance to prevent unnecessary flush to enter into the inserts.

• Knurling Available :

  • Diamond

  • Straight

  • Unidirectional

• Both blind and through inserts are available with no minimum Qty.

 Special Brass inserts Moulding Inserts Molding Brass inserts Available
 We shall be pleased to develop Non-Standard Brass inserts components  nuts screws studs fixings wood screws machine screws fasteners as per specific requirements.
 Materials
 Brass to BS 2874 / 2872
 Finish
 Brass natural, Electro-Tinned, Nickel etc.
 Threads
  ISO Metric, BSW, BA, BSF, UNC, UNF UNEF etc.

  Threads: 2mm 3mm 4mm 5mm 6mm 8mm 10mm 12mm 16mm 20mm 25mm 32mm
1/8" 5/32" 3/16" 1/4" 5/16" 3/8" 1/2" 5/8" 3/4" 1" 11/8" 11/4" 11/2" 13/4" 2"

BRASS STRAIGHT KNURLED MOULDING INSERTS

Features: They are  one one thro' hole Brass  inserts. They can be potted in or moulded. A straight knurl offers better torque out capabilities.

Sizes: from  2mm -10mm

---

BRASS HELICAL MOULDING INSERTS MOLDING NUTS

Features: They are compact inserts suitable for insertion in all types of plastics and can be used with hot plastic Moulding and cold plastic molding . Inserts  are best suitable for electrical moulded box application..

Sizes: from  2mm -12mm and 1/8" - 1/2"

---

Brass Inserts for CPVC and UPVC Drainage and Sewerage fitting Moulding

Features: These Brass inserts are used for UPVC moulding CPVC molding for dewerage and daringae pipe fittings elbows and Pipe couplings .

Sizes: from  1/4"mm -3/4" mm

---

BRASS INSERTS FOR WOOD AND PLASTIC

Features: These Brass inserts are push fit type and are used with Wood and plastic moulding. .

Sizes: from  1/4"mm -3/4" mm

---

BRASS SELF TAPPING INSERTS

Features: These inserts are suitable for installation with wide range of termoplastics and are sued where high pull out torque is required.

Sizes: from  1/4"mm -3/4" mm

---

BRASS KNURLED MOULDING SCREWS

Features: These screws are used for moulding of Nylon spacers and pillars.

Sizes: from  2mm-10mm and 1/8"-3/8"